Select Page

C Type Flex-Flex Couplings
The C Form coupling includes two flex hubs, one particular sleeve and one accessory kit consisting of seals and snap rings.
CFR Kind Flex-Rigid Couplings
The CFR Sort coupling consist of a single flex hub, one particular rigid hub, one particular sleeve, a single accessory kit consisting of seals and snap rings.
Attributes
Easy and economical type of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in place
Offered as vertical and horizontal couplings
Wide variety of particular variations which include full-flex, flex-rigid mill motor
Conventional configurations are available on the shelf
Ordering Facts
Application: Driver and Driven.
Sort and dimension of coupling, horizontal, vertical etc.
Electrical power: Motor horspower or torque requirement.
Pace: Motor RPM or Driven RPM.
Distance between shaft ends (BSE).
Shaft sizes.
C and CFR Sort Couplings
Ordering Info
Puller Holes are common on sizes 4 by 12.
Puller Holes can be found for sizes 7/8 by three.five at an additional charge.
The BSE (distance Among Shaft Ends) may possibly differ involving G and G1.
Interference bores with no set screws are regular except if otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, check with Engineering Segment.
Greater sizes can be found, please consult Technical Help.