Energy UNITS FOR LIFT TABLE

Power UNITS FOR LIFT TABLE one
General Description
This electrical power unit is built exclusively for the small lift table,Consisting of substantial stress gear pump, AC motor, multi-functional manifold, valves, tank, etc. This electrical power unit has been extensively applied while in the field of logistic products like minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is managed by the solenoid valve together with the pace managed by the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
Standard Description
This energy unit is developed exclusively for your medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve and also the velocity controlled through the adjustable needle valve. When the lift rises to a higher positoin, but the power provide is cut, the decreasing motion is controlled by the guide override function.
Power UNITS FOR LIFT TABLE three
Standard Description
This power unit is created exclusively for that huge lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve as well as the speed controlled by a strain compensated flow manage valve.
Power UNITS FOR LIFT TABLE four
Basic Description
This power unit is created solely for that substantial lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve plus the velocity controlled by the adjustable needle valve. Once the lift rises to a substantial positoin, but the energy provide is minimize, the lowering motion is managed through the guide override perform.
Exclusive Notes
1. This energy unit is of S3 duty cycle, which may only work intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean every one of the hydraulic parts concerned ahead of set up of the power unit.
3. Viscosity from the oil shoud be 15~46 cst,which should really also be clean and cost-free of impurities.N46 hydraulic oil is advisable.
4. Oil modifying is needed just after the original one hundred operation hrs,afterwards as soon as each 3000 hrs.
five. The power unit proven is designed to be mounted vertically.

Tags:

Recent Posts